Brodit Motorola MC65 Active Car Cradle Mount Tilt Swivel #513013

Please view compatibility tab below

Our Price: 61.77 (52.60 ex Vat.)

Item Number: 513013

Discounts available for orders of 10 units or more - call +44 1759 371275

Stock: 7

With tilt swivel, with Molex adapter system. 2A charger. Fits devices with standard and extended battery.

An active Car Cradle Mount which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior!

You can choose to use the Car Cradle Mount as an active Car Cradle Mount for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the Car Cradle Mount also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection).

12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. The Car Cradle Mount is attached onto a tilt swivel so you can easily adjust your device in order to avoid light reflection. Attach onto a Proclip Car Bracket Mount Mounting Platform.


If you order this product before 4:30pm today, and it is in Stock customers can expect shipment today. If you wish to pre-order or have stock allocated for immediate despatch upon restock please call us or place an order on the website.


These are detailed fitting Instructions for the Brodit Mount for your Motorola MC65 PDA. This is how you fit your Active Car Cradle Mount Tilt Swivel mount onto your Proclip Car Bracket Mount. Full Instructions also come with your mount.

Please read all of the instructions and look at the pictures before attaching the Car Cradle Mount. Important Note: Route the cable from the Car Cradle Mount into the vehicle dashboard and route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.



Enlarge image

1. Loosen the screw in the center of the Car Cradle Mount so you can remove the tilt swivel attaching plate on the back.



Enlarge image

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.




Enlarge image

3. Place the Car Cradle Mount over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the Car Cradle Mount is firmly in place, but still can be adjusted.



Enlarge image

4. The Car Cradle Mount is in place.







Motorola MC55 for All Countries
Motorola MC65 for All Countries
Motorola MC67 for All Countries

Symbol MC55 for All Countries
Symbol MC65 for All Countries
Symbol MC67 for All Countries






 

 



Thank you for adding your Brodit Car Cradle Mount. The Brodit Solution involves Two Steps. If you require a Brodit Car Bracket Mount then please select from the menus below. If you already have a Brodit Car Bracket Mount please proceed to checkout.